Compliance
FCC Notices
This equipment has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC rules. These limits exist to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with this instruction
manual may cause harmful interference in which case the user at his own expense
must take whatever measures may be required to correct the interference.
Shielded cables should be used to interconnect this unit with any peripheral
equipment (i.e., data sources, terminals, monitors, etc.) to ensure compliance with
Class A limits. Failure to do so may result in radio or TV interference.
Industry Canada Notice
This digital apparatus does not exceed the limits for Class A radio noise emissions
from digital apparatus as set out in the radio interference regulations of the
Canadian Department of Communications.
Le present appareil numerique n’emet pas de bruites radioelectriques qui dépassant
les limites applicables aux appareils numeriques de Class A prescrites dans le
reglement sur le brouillage radioelectrique edicte par le Ministre des
Communications du Canada.
Unauthorized Modifications
The manufacturer is not responsible for any radio or TV interference resulting from
unauthorized modifications made to this equipment. It is the responsibility of the
user to correct such interference at his own expense.
To Next Page
Loading...
