Dual Input COFDM Receiver Option
This card will input a (49 – 861 MHz) COFDM signal for use in electronic news
gathering (U.S.) or any COFDM Terrestrial Broadcast (DVB-T, European)
applications. The card provides A and B inputs, which may be independently
configured, but only one may be active at a time.
Quad Input DVB-S/DVB-S2 with LNB Power Option
This card will input a satellite L-band (950 MHz – 2150 MHz) signal for
demodulation of KU-band or C-band DVB-S QPSK signals or DVB-S2 QPSK/8PSK
signals. The symbol rate ranges from 1 MSym/s to 45 MSym/s for both DVB-S and
DVB-S2. This card provides LNB power and 22 kHz control tone to the active input.
This card has advanced feature options of multistream input, support for VCM, and
support for 16APSK and 32APSK modulation. The "Input" LED will only illuminate
if the card detects frequency, symbol rate, FEC lock (Carrier Lock), and TS sync
(Sync Lock). The card provides A, B, C and D inputs, which may be independently
configured, but only one may be active at a time.
CAM Decryption Option
This is a factory installed slot that will allow for up to two CAM cards to be installed
at a time, providing the D9887B receiver the ability to decrypt Conditional Access
transport streams.
Dual MPEG over IP Input/UDP Output Option
This card is a dual purpose card in that it can receive and/or transmit from the
internal TS bus, MPEG over IP. It has two physical connectors that can be configured
independently. Up to two multicasts can be subscribed to, allowing for a backup
multicast to be chosen and two UDP mirrored unicasts or multicasts can be
transmitted to allow for redundancy.
To Next Page
Loading...
Need help?
General
