Out of Order Packet Error Event – The IP connection has received an out of
order packet that is not able to be restored to its correct order.
Duplicate Packet Error – The IP connection has received a duplicate packet that
was discarded.
Not Receiving IP Packets Error –An incoming IP connection is no longer
receiving any packets.
IP TS Sync Loss Error – An incoming IP connection has lost its TS
synchronization, it could still be receiving packets.
DMIP Failover Backup Error – The Dual MPEG over IP Input/ UDP Output
option IP backup IP Receive Group is now being used as the Active Receive
Group.
DMIP Temperature Error – The Dual MPEG over IP Input/ UDP Output option
has exceeded its normal operating temperature limit.
Input Switched to Backup Error – The Backup input option has replaced the
Primary input option as the active input.
Line Conflict – An SDI output VANC line has a conflicting data trying to be
placed on the same line.
FEC Error Counter Rollover Event – The FEC error counter has restarted at 0.
FEC Error Counter Reset Event – There has been an FEC counter reset, setting all
of the FEC counters for the input option to 0.
AFD Code Not Present Event – The unit is configured to use or embed the AFD
code in the VANC, and the AFD code is not present with the input video.
Video
Video Not Decoding Error – The decoder did not receive a new video frame
within 3 seconds.
Video Type Error - Selected video stream format is not supported by the
decoder.
Video Unknown Error – Video Decoder does not recognize the video stream.
Video Conversion Error - The video stream cannot be converted.
Invalid Output Format Error - The output format selected is invalid for the
combination of incoming stream and output card.
Incompatible Genlock Error - The Genlock Reference selected by the user is
incompatible with the incoming stream format.
Genlock Reference Error - The Genlock reference is set but there is no reference
To Next Page
Loading...
