Cisco D9887B - Snmp; Ssh; Icmp

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
150 78-4043743-01 Rev A
SNMP
To enable/disable SNMP access to the D9887B receiver, use the following steps:
1 Press the Menu button.
2 Use the Up and Down buttons to move the cursor to "Network Services," then
press the Enter button.
3 Use the Up and Down buttons to move the cursor to "SNMP," then press the
Enter button.
4 Use the Up and Down buttons to change the selection, then press the Enter
button to save the selection.
SSH
To enable/disable SSH access to the D9887B receiver, use the following steps:
1 Press the Menu button.
2 Use the Up and Down buttons to move the cursor to "Network Services," then
press the Enter button.
3 Use the Up and Down buttons to move the cursor to "SSH," then press the Enter
button.
4 Use the Up and Down buttons to change the selection, then press the Enter
button to save the selection.
ICMP
To enable/disable ICMP access to the D9887B receiver, use the following steps:
1 Press the Menu button.
2 Use the Up and Down buttons to move the cursor to "Network Services," then
press the Enter button.