Cisco D9887B - Symbol Rate

Quad Input DVB-S/DVB-S2 Receiver with LNB Power Option
78-4043743-01 Rev A 91
Satellite Frequency
1 Use the Up and Down buttons to move the cursor to "Sat Freq," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the frequency (950 MHz – 14500 MHz), then press the
Enter button to save the selection.
Note: If a value entered results in a calculated L-Band that is out of range, an
"Out of Range!" message will be shown.
Note: The L-Band calculation is shown after the "Sat Freq" line. The valid L-Band
frequency range is 950 – 2150 MHz.
Symbol Rate
1 Use the Up and Down buttons to move the cursor to "Sym Rt," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the symbol rate (1 MSps – 45 MSps).
3 Press the Enter button to save the selection.