Cisco D9887B User Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
96 78-4043743-01 Rev A
3 Use the Up and Down buttons to move the cursor to "BISS Decryption," then
press the Enter button.
4 Press the Enter button again to edit the Source ID settings.
Note: For Configuration 2 units, all of the following instructions apply exactly
the same except, use the Right button to access the RDS 2 Decoder Menu.
5 Use the Up and Down buttons to move the cursor to "Mode," then press the
Enter button.
6 Use the Up and Down buttons to change the mode ("BISS 1" or "BISS E"), then
press the Enter button to save the selection.
Note: Depending on the mode selection, the menus below the mode options will
have changed.
Mode BISS 1
Once the D9887B receiver has been set to use Mode 1, use the following steps to
enter the session word:
1 Use the Up and Down buttons to move the cursor to "Session Word," then press
the Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to enter the session word, then press the Enter button to save the
selection.

Cisco D9887B Specifications

General

Brand	Cisco
Model	D9887B
Category	Receiver
Language	English