Mode BISS E
Once the D9887B receiver has been set to use Mode E, use the steps below to enter
the "Encrypted Session Word" and "Injected ID."
1 Use the Up and Down buttons to move the cursor to "Encrypt Session Word,"
then press the Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to enter the encrypted session word, then press the Enter button
to save the selection.
3 Use the Up and Down buttons to move the cursor to "Injected ID," then press the
Enter button.
4 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to enter the injected ID, then press the Enter button to save the
selection.
To Next Page
Loading...
