Cisco D9887B User Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
88 78-4043743-01 Rev A
ISI
Note: The setting of the "ISI" is only available when the "Multistream Mode" is set to
"On."
1 Use the Up and Down buttons to move the cursor to "ISI Mode," then press the
Enter button.
2 Use the Up and Down buttons to select either ("Manual", "List"), then press the
Enter button to save the selection.
Available ISI
The selection of ISI values are from the ones available within the multistream input.
Use the Up and Down buttons to select an ISI that is available in the multistream
input, then press the Enter button to save the selection.
Manual ISI
The ISI value is entered independent of the ISI values present in the input
multistream. This is used when the Source is being configured without the source
being the active input.
Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the ISI value (0 – 255), then press the Enter button to save
the selection.

Cisco D9887B Specifications

General

Brand	Cisco
Model	D9887B
Category	Receiver
Language	English