RDS CAM Usage Setting
The PIDs are sent to the CA System whenever it is enabled. When disabled, the PIDs
are not sent to the CA System for decryption.
1 Use the Up and Down buttons to move the cursor to "Descramble," then press
the Enter button.
2 Use the Up and Down buttons to change the setting ("Enabled" or "Disabled"),
then press the Enter button to save the selection.
Setting the CAM Operation Mode
1 Use the Up and Down buttons to move the cursor to "CAM Operation Mode,"
then press the Enter button.
2 Use the Up and Down buttons to change the mode ("Use Decoded PIDs" or "Use
Selected PIDs"), then press the Enter button to save the selection.
Note: Depending on the mode selection, the menus below the mode options will
have changed.
Use Decoded PIDs
In the "Use Decoded PIDs" operation mode, the CAM will decrypt the audio and
video programs that are decoded by the D9887B receiver. The Service Selection
tuning determines the program that is sent to the CAM for decrypting before the
decoding takes place. Only the program used for decoding is sent to the CAM no
matter how many programs the CAM is capable of decrypting. If programs other
than ( or in addition to) the one being decoded is to be sent to the CAM for
decryption, the "Use Selected PIDs" mode should be used.
To Next Page
Loading...
