Cisco D9887B User Manual

Dual MPEG over IP Input/ UDP Output Option
78-4043743-01 Rev A 109
Buffer
1 Use the Up and Down buttons to move the cursor to "Buffer," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the Buffer (from 3999 kb to 100 kb), then press the Enter
button to save the selection.
IGMP V3 Source Filter
Use the Up and Down buttons to move the cursor to "IGMP V3 Src Filter," then
press the Enter button to access the Edit screen.
Filter Mode
1 Use the Up and Down buttons to move the cursor to "Filter Mode," then press
the Enter button.
2 Use the Up and Down buttons to select either "Include" or "Exclude," then press
the Enter button to save the selection.
Add IP
1 Use the Up and Down buttons to move the cursor to "Add IP," then press the
Enter button.
2 Press the Enter button again to add an IP address to the list.
Note: Existing IP addresses are shown before the "Add IP" option.

Cisco D9887B Specifications

General

Brand	Cisco
Model	D9887B
Category	Receiver
Language	English