Cisco D9887B - Page 244

Appendix B
Specifications
220 78-4043743-01 Rev A
Audio Type Standard:
Compressed (IEC 60958)
Uncompressed (IEC 61937)
Closed Captions:
Embedded – EIA-708B or EIA-608B
Line 21 – Enabled/Disabled (selectable) SDI and
Composite controlled simultaneously
Analog Video -
Video Format Standards:
SMPTE-274M (1080i)
SMPTE-296M (720p)
SMPTE-253M (480p, 480i)
(reference EIA 770.2 and 770.3)
Number of Analog Outputs:
1 (shared: RGBHV or YPbPr/Composite via breakout
cable)
Connector:
High Density 15-pin D-sub, female
Impedance:
75 ohms, ±10%, 1 Kohm for syncs
Return Loss:
> 20 dB, 30 kHz – 30 MHz
Frequency Response:
Y = 30 kHz – 30 MHz, ± 0.2 dB ripple
PbPr = 30 kHz – 15 MHz, ± 0.2 dB ripple
H/V Sync:
4 Vpp into 1 Mohm, positive polarity
Composite Video Out –
Number of Outputs:
1 (NTSC/PAL)
Connector:
Breakout cable into BNC, female
Impedance:
75 ohms, +/-10%
Return Loss:
> 25 dB
Frequency Response:
DC to 6.0 MHz
Amplitude:
140 IRE (1.0 Vpp), +/-2 IRE
Display Modes:
Letterbox, cropped, anamorphic
NTSC
PAL
Standard:
ANSI/SMPTE 170M-1994; CCIR656
ITU.R.BT.470-6
Format, Frame rate:
525 lines, 29.97 Hz (Interlaced)
625 lines, 25.00 Hz
(Interlaced)
Setup (pedestal):
On/Off, selectable
Closed Caption:
Enable/Disable, selectable
CC Standard:
EIA-608B