Cisco D9887B - Page 49

Input Option – Active Input and Backup Configuration Selection
78-4043743-01 Rev A 25
Setting the Backup Input
1 Use the Up and Down buttons to move the cursor to the input shown as the
Backup Input, then press the Enter button.
2 Use the Up and Down buttons to select the input option to use as the Backup,
and then press the Enter button to save the selection.
Setting the Primary Restore Setting
1 Use the Up and Down buttons to move the cursor to the "Primary Restore"
setting, then press the Enter button.
2 Use the Up and Down buttons to select "Never", "When Primary Rtns", or "On
Backup Failure", and then press the Enter button to save the selection.
Setting the Backup Timeout Setting
1 Use the Up and Down buttons to move the cursor to the "Switchover" setting,
then press the Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to set the value of the timeout (3 – 45 seconds), then press the
Enter button to save the selection.