Cisco SPA303 Administration Guide

Cisco SPA IP Phone Field Reference
Info Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 229
B
RTP Packets Sent Total number of RTP packets sent (including redundant
packets).
RTP Bytes Sent Total number of RTP packets received (including
redundant packets).
RTP Packets Recv Total number of RTP bytes sent.
RTP Bytes Recv Total number of RTP bytes received.
SIP Messages Sent Total number of SIP messages sent (including
retransmissions).
SIP Bytes Sent Total number of SIP messages received (including
retransmissions).
SIP Messages Recv Total number of bytes of SIP messages sent (including
retransmissions).
SIP Bytes Recv Total number of bytes of SIP messages received
(including retransmissions).
External IP External IP address used for NAT mapping.
Operational VLAN ID ID of the VLAN currently in use if applicable.
NOTE Not applicable to WIP310.
SW Port (Cisco SPA300
Series and Cisco SPA500
Series)
Displays the type of Ethernet connection from the IP
phone to the switch.
PC Port (Cisco SPA303 and
Cisco SPA50X)
Indicates whether the link from the IP phone to a device
plugged into the PC port on the phone is up or down.
Parameter Description

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q