Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 234
B
Admin Passwd Password for the administrator.
Defaults to no password.
User Password Password for the user.
Defaults to no password.
SPA525-protocol (Cisco
SPA525G/525G2 only)
Allows you to choose the type of protocol for the
phone:
• SIP—Session Initiation Protocol. Choose if the
phone is used with a SIP call control system, such
as the Cisco SPA 9000 or a SIP call control system
from another provider such as BroadSoft or
Asterisk.
• SPCP—Smart Phone Control Protocol. Choose if
the phone is used with a Cisco Unified
Communications Series server, such as the Cisco
Unified Communications 500 Series for Small
Business.
SPA525-auto-detect-sccp
(Cisco SPA525G/525G2 only)
Choose if the phone should automatically detect the
type of protocol used on the network to which it is
connected. If set to yes, the phone automatically
discovers if it is connected to a call control system
using SPCP.
SPA525-readonly (Cisco
SPA525G/525G2 only)
If set to yes, the Signaling Protocol and Auto Detect
SCCP Settings on the phone are read only. If set to no,
the above settings on the phone can be changed by
the end user.
Phone-UI-user-mode Allows you to restrict the menus and options that
phone users see when they use the phone interface.
Choose yes to enable this parameter and restrict
access. The default is no.
Specific parameters are then designated as “na” or “ro”
using provisioning files. Parameters designated as “na”
will not appear on the user’s phone interface.
Parameters designated as “ro” will not be editable by
the user.
Parameter Description
To Next Page
Loading...
