Cisco SPA303 - Page 25

Getting Started
Using the Web-Based Configuration Utility
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 23
1
To access the IP phone configuration utility:
STEP 1 Launch a web browser on a computer that can reach the phone on the network.
STEP 2 Direct the browser to the IP address of the phone. To determine the IP address:
• Cisco SPA301: Press the asterisk (*) button four times. In the IVR menu, enter
110, then press #. The IP address is recited.
• Cisco SPA501G: Press the Setup button. In the IVR menu, enter 110, then
press #. The IP address is recited.
• Cisco SPA303, Cisco SPA502G, Cisco SPA504G, Cisco SPA508G, Cisco
SPA509G: Press the Setup button, then select Network. The
Current IP field
shows the phone’s current IP address.
• WIP310: In the Home screen, press Options and highlight
Phone Info . Press
the Select button.
• Cisco SPA525G/525G2: Press the Setup button, then select Status. Select
Network Status . The IP address is displayed.
STEP 3 Enter the IP address in your web browser address bar. For example:
http://192.168.1.8
NOTE If your service provider disabled access to the configuration utility, you must
contact the service provider.
If you have trouble accessing the configuration utility, perform the following steps:
Cisco SPA303, Cisco SPA502G, Cisco SPA504G, Cisco SPA508G,
Cisco SPA509G
STEP 1 Press the Setup button on the phone.
STEP 2 Select Network.
STEP 3 Scroll to Enable Web Server and make sure that it is set to Ye s . If not, press the
Edit soft key and press y/n soft key to set it to Yes .
STEP 4 Press OK, then press Save.