Cisco SPA IP Phone Field Reference
Regional Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 271
B
The <weekday> value equals any value in the range 1-
7 (Monday-Sunday). It can also equal 0. If the
<weekday> value is 0, this means that the date to start
or end daylight saving is exactly the date given. In that
case, the <day> value must not be negative. If the
<weekday> value is not 0 and the <day> value is
positive, then daylight saving starts or ends on the
<weekday> value on or after the date given. If the
<weekday> value is not 0 and the <day> value is
negative, then daylight saving starts or ends on the
<weekday> value on or before the date given.
The abbreviation HH stands for hours (0-23).
The abbreviation mm stands for minutes (0-59).
The abbreviation ss stands for seconds (0-59).
The default Daylight Saving Time Rule is start=4/1/
7;end=10/-1/7;save=1.
NOTE Found in the Time section for the Cisco
SPA525G/525G2.
Daylight Saving Time Enable Select yes to enable Daylight Saving Time.
NOTE Found in the Time section for the Cisco
SPA525G/525G2.
DTMF Playback Level Local DTMF playback level in dBm, up to one decimal
place.
Defaults to -16.
DTMF Playback Length Local DTMF playback duration in milliseconds.
Defaults to .1.
Inband DTMF Boost Controls the amount of amplification applied DTMF
signals.
Choices are OdB, 3dB, 6dB, 9dB, 12dB, 15dB, or 18dB.
Defaults to 12dB.
Parameter Description
To Next Page
Loading...
Need help?
General
