Cisco SPA303 Administration Guide

Cisco SPA IP Phone Field Reference
Phone Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 276
B
Select Logo Select from Default, BMP Picture, Text Logo, or None.
Defaults to Default.
NOTE Not applicable to the WIP310, SPA301, or
SPA501. On the Cisco SPA525G/525G2, this setting is
located in the User tab. See Screen (Cisco SPA525G/
525G2), page 314.
Select Background Picture Select from Default, BMP Picture, or None.
Defaults to Default.
NOTE Not applicable to the WIP310, SPA301, or
SPA501. On the Cisco SPA525G/525G2, this setting is
located in the User tab. See Screen (Cisco SPA525G/
525G2), page 314.
Softkey Labels Font Choose the font width for the softkey labels to display
on your phone. See Customizing Phone Softkeys,
page 62.
NOTE Not applicable to the WIP310, SPA301, or
SPA501.
Screen Saver Enable Enables a screen saver on the phone’s LCD. When the
phone is idle for a specified time, it enters screen saver
mode. (Users can set up screen savers directly using
phone Setup button.)
Any button press or on/off hook event triggers the
phone to return to its normal mode. (The screen shows
“Press any key to unlock your phone.”) If a user
password is set, the user must enter it to exit screen
saver mode.
NOTE Not applicable to the WIP310, SPA301, or
SPA501. Screen saver settings are found in the User tab
on the Cisco SPA525G/525G2.
Screen Saver Wait Amount of idle time before screen saver displays.
NOTE Not applicable to the WIP310, SPA301, or
SPA501. Screen saver settings are found in the User tab
on the Cisco SPA525G/525G2.
Parameter Description

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q