Cisco SPA303 Administration Guide

Cisco SPA IP Phone Field Reference
Phone Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 280
B
Remote Undefined LED LED pattern during the Remote Undefined state, where
the shared call state is undefined (the station is still
waiting for the state information from the application
server). Not applicable if the call appearance is not
shared. Leaving this entry blank indicates the default
value of c=r;p=d.
Local Seized LED LED pattern during the Local Seized state, where this
station has seized the call appearance to prepare for a
new outbound call. Leaving this entry blank indicates
the default value of c=r.
Remote Seized LED LED pattern during the Remote Seized state, where the
shared call appearance is seized by another station.
Not application if the call appearance is not shared.
Leaving this entry blank indicates the default value of
c=r;p=d.
Local Progressing LED LED pattern during the Local Progressing state, where
this station is attempting on this call appearance an
outgoing call that is in proceeding (i.e. the called
number is ringing). Leaving this entry blank indicates
the default value of c=r.
Remote Progressing LED LED pattern during the Remote Progressing state,
where another station is attempting on this shared call
appearance an outbound call that is progressing. Not
applicable if the call appearance is not shared. Leaving
this entry blank indicates the default value of c=r;p=d.
Local Ringing LED LED pattern during the Local Ringing state, when the
call appearance is ringing. Leaving this entry blank
indicates the default value of c=r;p=f.
Remote Ringing LED LED pattern during the Remote Ringing state, where
the shared call appearance is in ringing on another
station. Not applicable if the call appearance is not
shared. Leaving this entry blank indicates the default
value of c=r;p=d.
Local Active LED LED pattern during the Local Active state, where the
call appearance is engaged in an active call. Leaving
this entry blank indicates the default value of c=r.
Parameter Description

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q