Cisco SPA303 Administration Guide

Cisco SPA IP Phone Field Reference
User Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 315
B
Text Logo Text logo to display when the phone boots up. A service
provider, for example, can enter logo text as follows:
• Up to 2 lines of text
• Each line must be fewer than 32 characters
• Insert a new line character (\n) between lines
• Insert escape code %0a
For example, “Super\n%0aTelecom” will display:
Super
Telecom
For more information, see the “Configuring Phone
Information and Display Settings” section on page 46.
BMP Picture Download
URL
URL locating the bitmap (.BMP) or .jpg file to display on the
LCD background.
For more information, see the “Configuring Phone
Information and Display Settings” section on page 46
.
Logo Type Select from Default, Download BMP Picture, or Text Logo.
Defaults to Default.
For more information, see the “Configuring Phone
Information and Display Settings” section on page 46
.
Background Picture
Type
Select from Default, Download BMP Picture, or None.
Defaults to Default.
For more information, see the “Configuring Phone
Information and Display Settings” section on page 46.
LCD Contrast Enter a number value from 1 to 30. The higher the number,
the greater the contrast on the screen.
Back Light Enable Select yes to enable the screen back light.
Back Light Timer (sec) Enter the number of seconds before the back light should
turn off.
Parameter Description

Cisco SPA303 Specifications

General

Display	Monochrome LCD
Lines	3
Speakerphone	Yes
Headset Jack	Yes (2.5 mm)
Handset	Yes
Ethernet Ports	2 x 10/100 Mbps
Protocol	SIP
Power	Power over Ethernet (PoE) or AC adapter
Audio Codec Support	G.711, G.729
QoS	802.1p/q