OPERATING THE TRANSCEIVER
UPGRADING THE TRANSCEIVER VIA A USB STICK
ENVOY® TRANSCEIVER GETTING STARTED GUIDE 123
NOTE: You will be prompted to enter a self
address for each HF network that has
empty self address. For an HF network
that matches the name and call system
of an HF network already
programmed into the transceiver, you
will be able to keep the existing self
address.
• If you want to read the profile from the transceiver to
the USB stick, select Read Profile.
• If you want to upgrade the transceiver with a
firmware package on the USB stick, select
Upgrade Firmware.
• If you want to upgrade the RM50 module with a
RM50 firmware package on the USB stick, select
Upgrade RM50 Firmware.
NOTE: The RM50 module is a hardware
board optionally fitted in the Envoy
radio that enables DV options
with/without an AES-256 Encryption
upgrade and MIL/STANAG 2G Data
option. Please refer to Overview of
digital voice options on page 65 and
MIL/STANAG 2G Data on page 92 for
further information.
CAUTION: A permit from the Australian
government is required if you want to
upgrade the RM50 module with an
export controlled version firmware
package, which enables AES-256
Encryption and Low Rate DV
capabilities.
• If you want to program secure keys to a transceiver
that has an encryptor module enabled, select
Program Secure Keys.
CAUTION: If you have CES and AES DV
encryptors present, the keys for these
must be programmed simultaneously.
To Next Page
Loading...
Need help?
General
