Nano Series GigE Vision Camera Operational Reference • 107
Display Name Feature & Values Description
Device
Version
& View
Manufacturer Name DeviceVendorName Displays the device vendor name. 1.00
Beginner
Family Name DeviceFamilyName Displays the device family name. 1.00
Beginner
Model Name DeviceModelName Displays the device model name. 1.00
Beginner
Device Version DeviceVersion Displays the device version. This tag will also
highlight if the firmware is a beta or custom
design. (RO)
1.00
Beginner
Manufacturer Part
Number
deviceManufacturerPartNumber Displays the device manufacturer part
number.
1.00
DFNC
Beginner
Manufacturer Info DeviceManufacturerInfo This feature provides extended manufacturer
information about the device. Genie Nano
cameras show which firmware design is
currently loaded.
1.00
Beginner
Firmware Version DeviceFirmwareVersion Displays the currently loaded firmware version
number. Firmware files have a unique number
and have the .cbf file extension.
1.00
Beginner
Serial Number DeviceSerialNumber Displays the device’s factory set serial
number.
1.00
Expert
MAC Address deviceMacAddress Displays the unique MAC (Media Access
Control) address of the Device.
1.00
DFNC
Beginner
Device User ID DeviceUserID Feature to store a user-programmable
identifier of up to 15 characters. The default
factory setting is the camera serial number.
(RW)
1.00
Beginner
Device Built-In Self Test deviceBIST Command to perform an internal test which
will determine the device status. (W)
1.00
DFNC
Beginner
Device Built-In Self Test
Status
deviceBISTStatus Return the status of the device Built-In Self-
Test. Possible return values are device-
specific.
1.00
DFNC
Beginner
Passed Passed No failure detected
Last firmware update
failed
FirmwareUpdateFailure Last firmware update operation failed.
Unexpected Error Unexpected_Error Switched to recovery mode due to unexpected
software error.
Sensor Initialization
Failure
SensorFailure There was an error initializing the sensor. The
camera may not be able to capture images.
(1.05)
Firmware Error FirmwareError Firmware encountered an error during
streaming. (1.06)
Unknown Error
Returned
Unknown_Error Undefined single error or multiple
simultaneous errors. (1.08)
Device Built-In Self Test
Status All
deviceBISTStatusAll Return the status of the device Built-In Self-
Test as a bitfield. The meaning for each bit is
device-specific. A value of 0 indicates no
error.
Bit-0=1:Firmware Update Failure
Bit-2=1:Unexpected Error
1.00
DFNC
Beginner
Device Reset DeviceReset Resets the device to its power up state. (W) 1.00
Beginner
Device Temperature
Selector
DeviceTemperatureSelector Select the source where the temperature is
read.
1.00
Beginner
Internal Internal Value from FPGA and or PHY temperature.
To Next Page
Loading...
Need help?
General
