124 • Operational Reference Nano Series GigE Vision Camera
Auto-Brightness Control Category
The Genie Nano Auto-Brightness controls, as shown by CamExpert as a sub group to Sensor
Controls, has features used to configure the automatic gain function. Parameters in gray are read
only, either always or due to another parameter being disabled. Parameters in black are user set in
CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important, Genie
Nano cameras are available in a number of models implementing different sensors which may
support different features or none from this category.
Auto-Brightness Feature Descriptions
The following table describes these features along with their view attribute and device version. For
each feature the device version may differ for different camera sensors as they become available.
When a Device Version number is indicated, this represents the camera software functional group,
not a firmware revision number. As Genie Nano capabilities evolve the device version will increase,
therefore identifying the supported function package. New features for a major device version
release will be indicated by green text for easy identification.
Features are common for all Nano models unless indicated otherwise. Additionally the description
column will indicate which feature is a member of the DALSA Features Naming Convention
(indicated by DFNC), versus the GenICam Standard Features Naming Convention (SFNC tag is not
shown).
Note: Auto-Brightness not supported with model C4900 (18M Rolling Shutter).
To Next Page
Loading...
Need help?
General
