Dalsa Genie Nano Series User Manual

158 • Operational Reference Nano Series GigE Vision Camera
Color Processing Control Category
The Nano Color Processing control as shown by CamExpert has parameters used to configure the
color camera white balance/color balance features.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important,
Genie Nano cameras are available in a number of models implementing different sensors and
image resolutions which may not support the full feature set defined in this category.
Note that the following screen shows a color Nano with the optional RGB-Output Design firmware
loaded (certain models only). The last two features (Color Enhancement) are not offered with the
Standard Bayer Color firmware (used with all color Nano cameras).
Color Processing Control Feature Description
The following table describes these features along with their view attribute and device framework
version. For each feature the device version may differ for each camera sensor available. Such
differences will be clearly indicated for any applicable feature.
As Genie Nano capabilities evolve the device firmware version will increase, therefore identifying
the supported function package. New features for a major device version release will be indicated
by green text for easy identification.
The description column will indicate which feature is a member of the Teledyne DALSA Features
Naming Convention (denoted by DFNC), versus the GenICam Standard Features Naming
Convention (SFNC not shown).

Dalsa Genie Nano Series Specifications

General

Brand	Dalsa
Model	Genie Nano Series
Category	Security Camera
Language	English