206 • Operational Reference Nano Series GigE Vision Camera
Acquisition and Transfer Control Category
The Genie Nano Acquisition and Transfer controls as shown by CamExpert, has parameters used to
configure the optional acquisition modes of the device.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important, Genie
Nano cameras are available in a number of models implementing different sensors and image
resolutions which may not support the full feature set defined in this category.
To Next Page
Loading...
Need help?
General
