Dalsa Genie Nano Series User Manual

Nano Series GigE Vision Camera Operational Reference • 229
Display Name Feature & Values Description
Device Version
& View
Device Link Selector DeviceLinkSelector Selects which Link of the device to control
1.00
Expert
Device Link Throughput
Limit Mode
DeviceLinkThroughputLimitMode When disabled, lower level TL specific
features are expected to control the
throughput. When enabled,
DeviceLinkThroughputLimit controls the
overall throughput.
1.00
Guru
Off Off Disables the DeviceLinkThroughputLimit
feature.
On On Enables the DeviceLinkThroughputLimit
feature.
Device Link Throughput
Limit (in %)
DeviceLinkThroughputLimit Limits the maximum bandwidth of the
data that will be streamed out by the
device.
1.00
Beginner
Stream Channel Selector GevStreamChannelSelector Selects the stream channel to control. 1.00
Expert
Maximum Link Speed gevLinkSpeedLimit Maximum speed the device will advertise
during autonegotiation. Changes take
effect on the next boot.
1.00
Guru
Automatic Automatic Link speed limit is autonegotiated with the
device connected to the camera (switch or
NIC) at 1, 2.5 or 5 GigE.
2.5 GigE Speed_2500 2.5 GigE connection speed.
1 GigE Speed_1000 1 GigE connection speed.
Device Link Speed (in
Mbps)
GevLinkSpeed Indicates the transmission speed
negotiated by the given network interface.
1.00
Expert
PacketSize GevSCPSPacketSize Specifies the stream packet size in bytes
to send on this channel.
1.00
Expert
Interpacket Delay GevSCPD Indicates the delay (in µs) to insert
between each packet for this stream
channel. Note that Interpacket delay
becomes a Read-Only value when the
feature “Device Link Throughput Limit” is
enable.
1.00
Expert
Packet Resend Buffer Size devicePacketResendBufferSize Indicates the amount of memory to
reserve in Mbytes for the packet resend
buffer. Changes in reserved memory
affects total memory available for
acquisition buffering.
1.00
DFNC
Guru
IP Configuration Status GevIPConfigurationStatus Reports the current IP configuration
status. (RO)
1.00
Guru
None None Device IP Configuration is not defined.
PersistentIP PersistentIP Device IP Address Configuration is set to
Persistent IP (static).
DHCP DHCP Device IP Address Configuration is set to
DHCP (Dynamic Host Configuration
Protocol). Network requires a DHCP
server.
LLA LLA Device IP Address Configuration is set to
LLA (Link-Local Address). Also known as
Auto-IP. Used for unmanaged networks
including direct connections from a device
to a dedicated NIC.
ForceIP ForceIP Device IP Address Configuration is set to
ForceIP. Used to force an IP address
change.
Current IP Address GevCurrentIPAddress Reports the IP address for the given
network interface.
1.00
Beginner
Current Subnet Mask GevCurrentSubnetMask Reports the subnet mask of the given
interface.
1.00
Beginner
Current Default Gateway GevCurrentDefaultGateway Reports the default gateway IP address to
be used on the given network interface.
1.00
Beginner

Dalsa Genie Nano Series Specifications

General

Brand	Dalsa
Model	Genie Nano Series
Category	Security Camera
Language	English