Dell PowerConnect PC5524

154 Management ACL Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Management_ACL.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
deny [interface-id] [service service]
deny ip-source {ipv4-address | ipv6-address/ipv6-prefix-length} [mask {mask
| prefix-length}] [interface-id] [service service]
Parameters
• interface-id —Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port, Port-channel or VLAN
•
service service —Specifies the service type. Possible values are: Telnet,
SSH, HTTP, HTTPS and SNMP.
•
ipv4-address —Specifies the source IPv4 address.
•
ipv6-address/ipv6-prefix-length —Specifies the source IPv6 address and
source IPv6 address prefix length. The prefix length must be preceded by a
forward slash (
/ ). The parameter is optional.
•
mask mask —Specifies the source IPv4 address network mask. The
parameter is relevant only to IPv4 addresses.
•
mask prefix-length —Specifies the number of bits that comprise the source
IPv4 address prefix. The prefix length must be preceded by a forward slash
(
/ ). The parameter is relevant only to IPv4 addresses. (Range: 0–32)
Command Mode
Management Access-List Configuration mode
User Guidelines
Rules with ethernet, VLAN, and port-channel parameters are valid only if an
IP address is defined on the appropriate interface.
Example
The following example denies all ports in the access list called mlist.
Console(config)# management access-list mlist
Console(config-macl)#
deny