SNMP Commands 161
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\SNMP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
•
group-name
—Specifies the name of a group that should be configured
using the command
snmp-server group
with v1 or v2 parameter (no
specific order of the two command configurations is imposed on the user).
The group defines the objects available to the community. (Range: 1–30
characters)
•
type router
—Specifies that SNMP requests for duplicate tables configure
the router tables. This is the default.
•
type oob
—Specifies that SNMP requests for duplicate tables configure the
oob tables.
Default
No community is defined
Command Mode
Global Configuration mode
User Guidelines
You can’t specify view-name for su, which has access to the whole MIB.
You can use the view-name to restrict the access rights of a community string.
The logical key of the command is the pair (community, ip-address). If ip-
address is omitted then the key is (community, All-Ips).
By specifying the view-name parameter, the software:
• Generates an internal security-name.
• Maps the internal security-name for SNMPv1 and SNMPv2 security
models to an internal group-name.
• Maps the internal group-name for SNMPv1 and SNMPv2 security models
to view-name (read-view and notify-view always, and for rw for write-view
also),
You can use the group-name to restrict the access rights of a community
string. By specifying the group-name parameter the software:
• Generates an internal security-name.
• Maps the internal security-name for SNMPv1 and SNMPv2 security
models to the group-name.
To Next Page
Loading...
