354 PHY Diagnostics Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Phy_Diagnostics.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
show fiber-ports optical-transceiver [
interface interface-id] [detailed
]
Parameters
•
interface-id
—Specifies an interface ID. The interface ID must be an
Ethernet port.
•
detailed
—Displays detailed diagnostics.
Command Mode
EXEC mode
Example
The following examples display the optical transceiver diagnostics results.
console#
show fiber-ports optical-transceiver
Port Temp Voltage Current Output Input LOS
Power Power
----------- ------ ------- ------- ------ ----- ---
gi1/0/
1 W OK OK OK OK OK
gi1/0/
2 OK OK OK E OK OK
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power - Measured RX received power in milliWatts
LOS - Loss of signal
N/A - Not Available, N/S - Not Supported,
W - Warning, E - Error
To Next Page
Loading...
