Power over Ethernet (PoE) Commands 363
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
The following example displays information about the inline power for a
specific port.
console(config)# show power inline gi1/1/1
Port Powered Device State Status Priority Class
----- -------------- ------- ------ -------- -------
gi1/1/1 IP Phone Model A Auto On High Class0
Power limit (for port power-limit mode): 15.4W
Overload Counter: 0
Short Counter: 0
Denied Counter: 0
Absent Counter: 0
Invalid Signature Counter: 0
The following table describes the fields shown in the display:
Field Description
Power The inline power sourcing equipment operational status.
Nominal Power The inline power sourcing equipment nominal power in
Watts.
Consumed Power The measured usage power in Watts.
Usage Threshold The usage threshold expressed in percent for comparing
the measured power and initiating an alarm if threshold is
exceeded.
Traps Indicates if inline power traps are enabled.
Port The Ethernet port number.
Powered device A description of the powered device type.
Admin State Indicates if the port is enabled to provide power. The
possible values are Auto or Never.
Priority The port inline power management priority. The possible
values are Critical, High or Low.
Oper State Describes the port inline power operational state. The
possible values are On, Off, Test-Fail, Testing, Searching or
Fault.
To Next Page
Loading...
