Dell PowerConnect PC5524

402 Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
show bridge multicast address-table [vlan vlan-id] [address {mac-multicast-
address | ipv4-multicast-address | ipv6-multicast-address}] [format {ip |
mac}]
Parameters
• vlan vlan-id —Specifies the VLAN ID.
•
address {mac-multicast-address | ipv4-multicast-address | ipv6-
multicast-address}
—Specifies the multicast address. The possible values
are:
• mac-multicast-address—Specifies the MAC multicast address.
• ipv4-multicast-address—Specifies the IPv4 multicast address.
• ipv6-multicast-address—Specifies the IPv6 multicast address.
• format { ip | mac }—Specifies the multicast address format. The possible
values are:
• ip—Specifies that the multicast address is an IP address.
• mac—Specifies that the multicast address is a MAC address.
Default Configuration
If the format is not specified, it defaults to mac.
Command Mode
EXEC mode
User Guidelines
A MAC address can be displayed in IP format only if it is within the range
0100.5e00.0000 through 0100.5e7f.ffff.
Multicast Router ports (defined statically or discovered dynamically) are
members in all MC groups.
Ports that were defined via bridge multicast forbidden forward-all command
are displayed in all forbidden MC entries.
Example
The following example displays bridge multicast address information.
Console# show bridge multicast address-table