GVRP Commands 549
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\GVRP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
• join—Specifies the GARP join timer. The GARP join timer value
specifies the time interval between the two join messages sent by the
GARP application.
• leave—Specifies the GARP leave timer. The GARP leave timer value
specifies the time interval for a GARP application to wait for a join
message after receiving a leave message for a GARP attribute, before it
de-registers the GARP attribute.
• leaveall—Specifies the GARP leaveall timer. The GARP leaveall timer
value specifies the time interval between leaveall messages for a GARP
entity, which prompt other GARP entities to re-reregister all attribute
information on this entity.
•
timer-value
—Specifies the timer value in milliseconds in multiples of 10.
(Range: 10–2147483640)
Default Configuration
The following are the default timer values:
•
Join timer
—200 milliseconds
•
Leave timer
—600 milliseconds
•
Leaveall timer
—10000 milliseconds
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
The timer-value value must be a multiple of 10.
The following relationship must be maintained between the timers:
• The leave time must be greater than or equal to three times the join time.
• The leave-all time must be greater than the leave time.
Set the same GARP timer values on all Layer 2-connected devices to ensure
proper operation of the GARP application.
To Next Page
Loading...
