697
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\ACL.fm
DELL CONFIDENTIAL – PRELIMINARY 2012 - FOR PROOF ONLY
• dscp number—Specifies the DSCP value.
• precedence number—Specifies the IP precedence value.
• icmp-type—Specifies an ICMP message type for filtering ICMP packets.
Enter a number or one of the following values: echo-reply, destination-
unreachable, source-quench, redirect, alternate-host-address, echo-
request, router-advertisement, router-solicitation, time-exceeded,
parameter-problem, timestamp, timestamp-reply, information-request,
information-reply, address-mask-request, address-mask-reply, traceroute,
datagram-conversion-error, mobile-host-redirect, mobile-registration-
request, mobile-registration-reply, domain-name-request, domain-name-
reply, skip, photuris. (Range: 0–255)
• icmp-code—Specifies an ICMP message code for filtering ICMP
packets. (Range: 0–255)
• igmp-type—IGMP packets can be filtered by IGMP message type. Enter
a number or one of the following values: host-query, host-report, dvmrp,
pim, cisco-trace, host-report-v2, host-leave-v2, host-report-v3. (Range:
0–255)
• destination-port—Specifies the UDP/TCP destination port. You can
enter range of ports by using hyphen. E.g. 20 - 21. For TCP enter a
number or one of the following values: bgp (179), chargen (19), daytime
(13), discard (9), domain (53), drip (3949), echo (7), finger (79), ftp
(21), ftp-data (20), gopher (70), hostname (42), irc (194), klogin (543),
kshell (544), lpd (515), nntp (119), pop2 (109), pop3 (110), smtp (25),
sunrpc (1110, syslog (514), tacacs-ds (49), talk (517), telnet (23), time
(37), uucp (117), whois (43), www (80). For UDP enter a number or one
of the following values: biff (512), bootpc (68), bootps (67), discard (9),
dnsix (90), domain (53), echo (7 ), mobile-ip (434), nameserver (42),
netbios-dgm (138), netbios-ns (137), on500-isakmp (4500), ntp (123),
rip (520), snmp (161), snmptrap (162), sunrpc (111), syslog (514),
tacacs-ds (49), talk (517), tftp (69), time (37), who (513), xdmcp
(177).(Range: 0–65535).
• source-port—Specifies the UDP/TCP source port. Predefined port names
are defined in the destination-port parameter. (Range: 0–65535)
• match-all list-of-flags—List of TCP flags that should occur. If a flag
should be set, it is prefixed by “+”. If a flag should be unset, it is prefixed
by “-”. Available options are +urg, +ack, +psh, +rst, +syn, +fin, -urg, -
To Next Page
Loading...
