Quality of Service (QoS) Commands 739
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\QoS.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
no wrr-queue cos-map [
queue-id
]
Parameters
•
queue-id
—Specifies the queue number to which the CoS values are
mapped.
•
cos0 ... cos7
—Specifies up to 7 CoS values to map to the specified queue
number. (Range: 1–7)
Default Configuration
The default CoS value mapping to 8 queues is as follows:
CoS value 0 is mapped to queue 3.
CoS value 1 is mapped to queue 1.
CoS value 2 is mapped to queue 2.
CoS value 3 is mapped to queue 4.
CoS value 4 is mapped to queue 5.
CoS value 5 is mapped to queue 6.
CoS value 6 is mapped to queue 7.
CoS value 7 is mapped to queue 8.
Command Mode
Global Configuration mode
User Guidelines
Use this command to distribute traffic to different queues, where each queue
is configured with different weighted round robin (WRR) and Weighted
Random Early Detection (WRED) parameters.
The expedite queues are enabled using the priority-queue out Interface
Configuration mode commans
Example
The following example maps CoS value 7 to queue 2.
Console(config)#
wrr-queue cos-map
2 7
To Next Page
Loading...
