Field Service Ver. 1.0 Aug. 2005 8. Maintenance Mode
27
FK-503Adjustment / Setting
8. Maintenance Mode
8.1 Maintenance Mode Function Setting Procedure
A. Procedure
1. Press the Utility/Counter key.
2. Touch [Check Detail].
3. Press the following keys in this order.
Stop → 0 → 0 → Stop → 0 → 2
4. Touch [Maintenance Mode].
5. Type the 8-digit service code and touch [Enter]. (Default value: 00000000)
NOTE
• When [END] is touched after a wrong service code has been entered, the Basic
screen reappears.
• At the fourth access after entries of three wrong access codes, [END] is not avail-
able on the screen. It is therefore necessary to turn OFF and ON the Main Power
Switch.
• If you forget the service code, it becomes necessary to replace the RAMS Board
with a new one. Take necessary steps not to forget the service code.
• The RAMS Board is not available as a replacement part. If it requires replacement,
contact Office Printing Support Division by way of CSES.
6. The Maintenance Mode menu will appear.
NOTE
• To change the service code, see “Service Security Mode.”
B. Exiting
• Touch the [Exit] key.
NOTE
• The Maintenance mode is not disclosed to users. After the job is completed, there-
fore, be sure to exit the mode by turning OFF and ON the Main Power Switch.
4040F3E562DA
To Next Page
Loading...
