8. Mechanical adjustment Field Service Ver. 1.0 Aug. 2005
32
FS-508/PU-501/OT-601
Adjustment / Setting
8.4 Punch Hold Position Adjustment (PU-501)
1. Set the copier into the Hole Punch
mode and make a 1-sided copy from
a 1-sided original.
2. Check width A on the output paper.
3. Display the Tech. Rep. Mode screen.
☞ For details of how to display the
Tech. Rep. Mode screen, see the
Adjustment/Setting of the main unit
service manual.
4. Touch [Tech. Rep. Choice].
5. Touch [Finisher].
6. Touch [Punch Stop Position].
7. Press the Clear key and use the 10-
Key Pad to set the value.
• To make width A wider, enter a posi-
tive value.
• To make width A narrower, enter a
negative value.
Adjustment range: +10 max. and -10
min.
1 increment: 0.5 mm
Use the ✽ key to switch between + and -.
4349F3C511DA
A
4349F3E521DA
4349F3E522DA
4349F3E523DA
To Next Page
Loading...
