Develop ineo 250 - Settings in the Printer Setting

Field Service Ver. 1.0 Aug. 2005 9. Utility/Counter Mode
141
bizhub 200/250/350Adjustment / Setting
9.7 Settings in the Printer Setting
9.7.1 MFP Set
A. Proof Print Hold Time
B. Overwrite A4←→Letter
C. Document Hold Time
D. PostScript Error Report
9.7.2 Default Set
A. Basic
(1) Tray
Functions
• To change the hold time of the proof print job.
Use
Setting/
Procedure
• The default setting is “10 min.”
“10 min.” 20 min. 30 min.
Functions • To set whether to enable or disable the override function of A4 and Letter.
Use
• To enable the function that allows Letter to be used instead of A4, or vice versa, for
printout.
Setting/
Procedure
• The default setting is “OFF”.
ON “OFF”
Functions
• To change the hold time of print data invoked when a condition, in which memory
capacity has exceeded, at the expiration of which the print data is discarded.
Use
Setting/
Procedure
• The default setting is “5Min”.
• Setting range: 0 to 30
Functions
• To set whether or not to print error information when an error occurs during computer
printing.
Use • To print error information when an error occurs during computer printing.
Setting/
Procedure
• The default setting is “OFF”.
ON “OFF”
Functions
• To set a paper source when none is specified by the printer driver during computer
printing.
Use
• To specify a paper source when one cannot be specified by the printer driver during
printing from Windows DOS or in a similar case.
Setting/
Procedure
• The default setting is “Auto Paper Select”.