Develop ineo 250 - Page 414

Field Service Ver. 1.0 Aug. 2005 11. Soft Switch List
45
FK-503Adjustment / Setting
038 0A 0A Turn on print lamp for out-of print paper, Print stop/start *
039 00 00 (Undefined)
040 FA FA 2-dim coding, T.6 coding, JBIG, V34JBIG
041 40 40 ECM mode
042 3F 3F Redialing interval *
043 80 80 # of resending doc., Redialing non-answered call
044 80 80 RTN sending error, Action against abnormal overseas communications, T4
timer
045 D4 D4 (Undefined)
046 00 00 (Undefined)
047 88 88 V34 fallback tolerance
048 C6 C6 Set up MODEM standard
049 0D 0D Transmission speed upper limit (TX)
050 0D 0D Transmission speed upper limit (RX)
051 20 20 Declare RX print paper size
052 00 00 (Undefined)
053 C8 C8 Sender’s character code size
054 7A 7A History control of V.34 auto dialing, Demodulation method
055 02 02 (Undefined)
056 0C 0C F code function
057 19 19 Time that ANSam TX starts after line is blocked
058
|
076
3C
|
14
3C
|
14
(Undefined)
077 60 60 Hook monitoring counts
078 00 00 (Undefined)
079 02 02 (Undefined)
080 23 6E Estimated time of line connection (PSTN1)
081 00 00 (Undefined)
082 04 24 Detect busy tone, Detect line disconnection (inverted polarity) (PSTN1)
083 50 50 Hook monitoring cycle, Hook detection voltage (PSTN1)
084 14 28 PB sending lever (PSTN1)
085 90 C0 TX level (PSTN1)
086 40 40 RX attenuator (PSTN1)
087 90 90 Detect continuous ringer, Ringer detection frequency (PSTN1)
088 C0 C0 Process detection time out of 2nd dial tone, 1300 Hz detection (PSTN1)
089 00 00 TX method, Prefix # (PSTN1) *
090 00 00 (Undefined)
091 00 00 (Undefined)
092 70 70 Sending echo protection tone, switch carrier frequency (PSTN1)
093 48 40 CED, Receive command echo (PSTN1)
MODE
HEX
(For
U.S.)
HEX
(For
Europe)
Remark