C
HAPTER
3
| Using the Web Interface
Navigating the Web Browser Interface
ā 57 ā
Aggregation 128
Static Specifies ports to group into static trunks 129
LACP Allows ports to dynamically join trunks 132
Spanning Tree 135
Bridge Settings Configures global bridge settings for STP, RSTP and MSTP;
also configures edge port settings for BPDU filtering, BPDU
guard, and port error recovery
137
MSTI Mapping Maps VLANs to a specific MSTP instance 140
MSTI Priorities Configures the priority for the CIST and each MISTI 142
CIST Ports Configures interface settings for STA 143
MSTI Ports Configures interface settings for an MST instance 147
IGMP Snooping 149
Basic
Configuration
Configures global and port settings for multicast filtering 149
VLAN
Configuration
Configures IGMP snooping per VLAN interface 152
Port Group
Filtering
Configures multicast groups to be filtered on specified port 153
MLD Snooping 154
Basic
Configuration
Configures Multicast Listener Discovery Snooping 155
VLAN
Configuration
Configures MLD snooping per VLAN interface 158
Port Group
Filtering
Configures multicast groups to be filtered on specified port 159
MVR Configures Multicast VLAN Registration, including global
status, MVR VLAN, port mode, and immediate leave
160
LLDP Link Layer Discovery Protocol 163
LLDP Configures global LLDP timing parameters, and port-specific
TLV attributes
163
LLDP-MED Configures LLDP-MED attributes, including device location,
emergency call server, and network policy discovery
166
MAC Table Configures address aging, dynamic learning, and static
addresses
172
VLANs Virtual LANs 174
VLAN Membership Configures VLAN groups 175
Ports Specifies default PVID and VLAN attributes 176
Private VLANs
PVLAN
Membership
Configures PVLAN groups 178
Port Isolation Prevents communications between designated ports within
the same private VLAN
180
Voice VLAN 181
Table 4: Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
