DURKOPP ADLER 755 A

Programming
336 Service Instructions 755 A/756 A - 00.0 - 02/2019
To select the piping type:
1. Press the desired button.
2. Enter the desired value using the numeric keypad.
3. Confirm with OK.
Spread transport clamp
The display switches to Spread transport clamp.
Fig. 316: Spread transport clamp
To spread the transport clamp:
1. Press the desired button.
2. Enter the desired value using the numeric keypad.
3. Confirm with OK.
Symbols Meaning
Correction value left before corner cut
• -1.0 mm - 1.0 mm
Correction value right before corner cut
-1.0 mm - 1.0 mm
Spread transport clamp On/Off
Spread clamp left before transport start
• -1.0 mm - 1.0 mm
Spread clamp right before transport start
• -1.0 mm - 1.0 mm