Programming
Service Instructions 755 A/756 A - 00.0 - 02/2019 429
User password setup
Information
To set up a user password, the user password option must be activated in
the Global parameters ( p. 362).
If a user password already exists, you need to enter this password before
you can create a new user password.
To activate password protection, you need to restart the machine.
When the machine starts up, you will be prompted to enter the user
password you created.
Fig. 392: User password setup (1)
To set up a user password:
1. Enter the desired 4-digit PIN.
2. Confirm with OK.
3. Re-enter the password (password check)
4. Confirm with OK.
To Next Page
Loading...
Need help?
General
