Programming
Service Instructions M-TYPE DELTA - 00.0 - 12/2019 131
19.4.4 Setting the Stop Positions parameters
Various settings can be made for the stop positions. The possibilities are
explained in more detail in the table.
19.4.5 Setting the Sewing foot lift parameters
Various settings can be made for the sewing foot. The possibilities are
explained in more detail in the table.
Icon Menu items Value range
Lower needle position
Holding position of the needle in the
material.
• Value range
000 - 359
Threading position
Position for the proper function of the
threader, e.g. with thread lever at top dead
center.
• Value range
000 - 359
Needle up position
Holding position of the needle outside of
the material.
• Value range
000 - 359
Needle position after turn back
Stop position after thread cutting (reversal
position).
• Value range
000 - 359
Icon Menu items Value range
Max. sewing foot lifting height • Value range with
standard FA
01.0 – 20.0 [mm]
• Value range with KFA
01.0 – 18.0 [mm]
Step motor speed
Speed at which the sewing feet will be
lifted.
• Value range
01 - 60