Adjusting feed dog and needle bar linkage
50 Service Instructions M-TYPE DELTA - 00.0 - 12/2019
7.5 Aligning the feed dog in the sewing direction
Order
Align the needle bar linkage in the sewing direction first ( p. 49).
Fig. 36: Aligning the feed dog in the sewing direction
To align the feed dog in the sewing direction:
1. Execute the service routine Feed dog > Position to
needle ( p. 14).
The software is used to define the necessary presettings on the
machine.
2. Open the throat plate slides ( p. 28).
3. Tilt the machine head ( p. 18).
4. Loosen the screw (1).
5. Align the feed dog in the sewing direction such that the needle pierces
in the center of the needle hole.
6. Tighten the screw (1).
Order
Next, check the feed dog movement relative to the throat plate cutout at
maximum stitch length.
(1) - Screw
To Next Page
Loading...
