DURKOPP ADLER D867 M-Type Delta User Manual

Programming
150 Service Instructions M-TYPE DELTA - 00.0 - 12/2019
19.4.26 Setting the Input/Output Configuration parameters
Input Configuration
Configure and allocate the inputs here.
Each input can be assigned one of the following modes.
• Bobbin Wind mode
• Bartack suppression/activation
• Manual bartack
• Half stitch
• Whole stitch
• Pointing Position
• Needle high
• Needle cooling
• Additional thread tension
• Stitch length switching
• Seam Center Guide
• Light barrier
• Operation lock active with contact open
• Quick stroke adjustment
• Switch to next segment
•2
nd
edge guide position (gap)
• Foot lighten position
• Additional fullness
• Tape tension
•Puller
• Operation lock active with contact closed
• Operation lock in seam
• Trigger program selection
• Program selection Bit B0
• Program selection Bit B1
• Program selection Bit B2
• Program selection Bit B3
• Program selection Bit B4
• Program selection Bit B5
• Program selection Bit B6
• Program selection Bit B7
• Program selection Bit B8
• Program selection Bit B9
• Short stitch
•2
nd
edge guide position (height)

DURKOPP ADLER D867 M-Type Delta Specifications

General

Brand	DURKOPP ADLER
Model	D867 M-Type Delta
Category	Sewing Machine
Language	English