DURKOPP ADLER D867 M-Type Delta User Manual

Programming
138 Service Instructions M-TYPE DELTA - 00.0 - 12/2019
19.4.10 Setting the Holding force parameters
Various settings can be made for the holding force of the motor.
The possibilities are explained in more detail in the table.
Bobbin rotation monitor
• Value range
On/Off
Length
Seam length before the
bobbin rotation monitor
starts.
• Value range
000 – 255 [mm]
Remaining thread monitor limit • Value range
0.0-4.0
Values only apply to
the remaining thread
monitor, not the SSD.
Remaining thread monitor
intensity
• Value range
0.0-4.0
Values only apply to
the remaining thread
monitor, not the SSD.
Icon Menu items Value range
Icon Menu items Value range
Mode Holding Position
• Value range
On/Off/Holding
Position
Holding Position: the
sewing motor is always
regulated to this
position. It is not
possible to change the
position by using the
handwheel or setting
additional parameters.
Max. Current
Holding current of the motor
only visible if the
parameter is activated
• Value range
00 - 50
Response
Response time for the continuous current
only visible if the
parameter is activated
• Value range
000 - 100

DURKOPP ADLER D867 M-Type Delta Specifications

General

Brand	DURKOPP ADLER
Model	D867 M-Type Delta
Category	Sewing Machine
Language	English