Emerson PACSystems RSTi-EP - Navigation and Operating Instructions; Setting the Language

User Manual Section 9
GFK-2958L May 2021
Web Server 459
Figure 304: Display of the Connected Station following Registration
Note: The web server only registers modules that can communicate on the system bus.
Empty slot modules and other passive modules (for example, AUX modules) are not
registered by the web server and therefor are not displayed in the screen view.
Because of this, the numbering of the modules in the web server view may deviate
from the count in the actual station.
9.4 Navigation and Operating Instructions
9.4.1 Setting the Language
When the program is started, the web server attempts to start with the language set in your
web browser. If this language is not supported by the web server, the program starts with
the English setting.
New language versions are continually being developed and can be later installed by the
user with separate language files.
•
To change the language: Click Language and select the desired setting.