User Manual Section 9
GFK-2958L May 2021
Web Server 462
•
Change the registration data and set up password protection to limit access to the
web server
•
Reset any changes that have been made
•
Access the network adapter parameters
•
Access the network adapter's datasheet (link to product designation)
9.5.1 Resetting the Web Server
You can undo all the changes that have been made since the last time that the web server
was started.
Note: After a reset, the network adapter is restarted. All data not protected against power
failure is reset.
•
To reset the web server
1.
Click on the network adapter.
2.
From the Network Adapter Status dialog box, click Reset.
Figure 309
9.5.2 Resetting the Network Adapter to Factory Settings
This function allows you to set up the web server in its original state as at delivery. This also
includes registration data and password protection.
•
To reset the network adapter to factory settings
1.
Click on the network adapter.
2.
From the Network Adapter Status dialog box, click Factory settings.
Figure 310
To Next Page
Loading...
