Epson WorkForce Enterprise WF-C21000 Series - Page 385

2.
Select General Settings > Network Settings > Standard > Advanced.
3.
Select Proxy Server.
4.
Select Use for Proxy Server Settings.
5.
Enter the address for the proxy server by IPv4 or FQDN format.
Conrm the value reected on the previous screen.
6.
Enter the port number for the proxy server.
Conrm the value reected on the previous screen.
7.
Tap Start Setup.
Connecting to Ethernet (When Using an Additional Network)
Connecting to Ethernet on the Standard Network
Connect the printer to the standard network by using an Ethernet cable, and then check the connection.
1.
Connect the printer and hub (LAN switch) by Ethernet cable.
2.
Select Settings on the home screen.
3.
Select General Settings > Network Settings > Standard > Connection Check.
e
connection diagnosis result is displayed.
Conrm
the connection is correct.
4.
Tap OK to nish.
When you tap Print Check Report, you can print the diagnosis result. Follow the on-screen instructions to
print it.
Connecting to Ethernet on an Additional Network
Connect the printer to the additional network by using an Ethernet cable, and then check the connection.
1.
Connect the printer and hub (LAN switch) by Ethernet cable.
2.
Select Job/Status on the home screen.
3.
Select the Printer Status tab, and then select the Options tab.
e Ethernet connection status is displayed. Conrm the connection is correct.
Selecting the Network Transmission Route (When Using an Additional
Network)
e following scan and fax functions are available from the printer's control panel on either the standard or
additional network.
Using Optional Items > 10/100/1000 Base-T,Ethernet > Settings when Using an Additional Network
385