System Basics 117
Custom Direct Selects
Whereas direct selects display lists of specific target types, custom direct selects allow you to
create a list with individual targets, regardless of type. The custom direct selects editor allows
you to choose the targets used in these lists, and apply them to a configurable grid.
To open the custom direct selects editor, select the custom direct selects icon on the
Workspace Layout Menu (on page90)
, or use [Tab] [3] [9]. You can also choose {Custom} on
the direct selects tab, and then selecting {Open Custom DSEditor}.
The editor is divided into a preview of your custom direct selects grid, a target selection menu
for configuring buttons, and an index of all custom direct select lists in your show file.
Custom direct select lists can be any number between 0.001 and 9999.999.
Preview (1)
This section displays the custom direct select list, laid out on a customizable grid for you to
preview layouts. The options at the top allow you to adjust the number or rows and / or
columns in your custom direct select grid, or choose from preset grid layouts.
Target Selection Menu (2)
This section allows you to configure which direct select targets are assigned to your custom
direct select buttons. All buttons default to empty.
Custom Direct Selects (3)
This section displays an index of all the custom direct select lists in your show file. These lists
can be assigned a label, as well as an icon.
Note:
Custom direct selects created in Eos software prior to v3.1.0 and stored in
snapshots will be automatically converted to a custom direct select list, labeled with
the relevant snapshot number.
To Next Page
Loading...
Need help?
General
