Groups 259
When a group is previewed using the Group List, the display defaults to showing the ordered
view. Channels can be reordered as needed from this list. Use the [Format] key to change to a
numeric listing of channels.
Example:
[1] [0] [Thru] [2] [Record] [Group] [1] [Enter]
This will record channels 10 through 2 to Group 1, and then if you select the
group you can cycle through the channels using [Next] starting with 10, then
9, then 8, and so on.
The following softkeys are available:
{Insert Before} - use to insert a new channel after the specified channel within a group.
{Insert After} - use to insert a new channel before the specified channel within a group.
{Reverse} - use to place a group's channels in reverse order.
{Random} - use to place a group's channels in a random order.
{Reorder} - use {Reorder} to rearrange the channels to numeric order in a group.
{Offset} - See
Offset (on page226)
for more information.
Subgroups
You can create subsets of channels within a group by using [Shift] & [/] to create parentheses.
The subgroups will display within those parentheses.
These subsets of channels or subgroups are treated as a single channel in the following ways:
When applying absolute or relative effects from live, the subgroups are treated as a
single channel by the effect.
When setting a range of step's channels on a step based effect, the subgroup will not be
spread out amongst multiple steps.
When the group is selected and next/last is pressed, each subgroup is traversed.
When a group has subgroups, {Reverse}, {Reorder}, and {Random} in the group editor
will affect the subgroups instead of the channels in each subgroup. {Reorder} will order
the groups based on the first channel in each subgroup.
Subgroups can be created either in the group list or Live.
To create a subgroup in Live:
[Shift] & [/] [1] [Thru] [4] [Shift] & [/] [Record] [Group] [2] [Enter]
To create a subgroup in the group list index:
[Group] [2] [Enter] [Shift] & [/] [1] [Thru] [4] [Shift] & [/] [Enter]
Editing and Updating Groups in Live
Existing groups can be updated or re-recorded in Live. If you re-record an existing group, a
confirmation is required (unless disabled in Setup). By re-recording a group, you replace the
contents of the group, you do not add to it. Updating a group does not require a confirmation
and adds channels to the group, rather than replacing them.
Other editing or updating examples are:
To Next Page
Loading...
