Console Overview 29
control for external monitors.
CAUTION:
The USB data ports cannot be used for charging devices.
Charging Ports
Two USBA ports, capable of delivering 5A / 12.5W of power each, are available for charging
devices. One is located under the encoder display on the front right of the desk. The other is
located under the faders on the front left of the desk (Apex 5), or inside the accessory drawer
(Apex 10 and 20).
Task Lights
Littlites®
You may connect Littlites to the back of your console.
Book Lights
Two independently-controlled, warm-white work lights are available on the left and right sides
of Apex consoles for illumination of nearby work surfaces.
Dimming Task Lights
Task lights can be dimmed from within Eos, under Setup > Device > Brightness Settings. The
{Desk Lamp} slider has a range of 0% (dimmest) to 100% (brightest). The default setting is
0%. The console will set the desk lamp to this setting on startup of the application. See
Brightness Settings (on page219)
for more information.
Task lights can also be controlled by holding down [Displays] and rolling the level wheel.
WARNING: This device contains a lithium battery. Battery may explode if
mistreated. Do not recharge, disassemble or dispose of in fire.
Eos Apex 20 Capacities
Output Parameters
24,576
Channel Counts
32,768 channels (can be any number from 1 to 99,999)
Cues and Cue List
999 cue lists
10,000 cues
To Next Page
Loading...
Need help?
General
